Page 1 of 1

Chainplates

Posted: Mon Apr 05, 2010 8:53 pm
by Drew
Chainplates are in.

Image

Re: Chainplates

Posted: Wed Apr 07, 2010 3:13 pm
by falcon
Drew,

Nice looking instalation. Could you provide some details on how you fashioned the raised pieces surrounding the chainplates? Or did I miss that on an earlier post?
Pete

Re: Chainplates

Posted: Wed Apr 07, 2010 6:46 pm
by Drew
The cover-plates are made from 1/4" fiberglass sheet and painted. There is a generous bevel cut in the bottom of the slot where the chainplate penetrates the cover-plate and also in the deck. I added the bevel as a way to hold more sealant adjacent to the chainplate.

As for fabrication:
I cut them out with a hacksaw, rounded the corners with a palm sander, cut the slots with a carbide burr in a dremel, and squared the corners of the slots with a file.

The cover-plates and the chainplates are bedded in copious amounts of sika 291.

drew

Re: Chainplates

Posted: Wed Apr 07, 2010 7:37 pm
by Hirilondë
Sounds like a top shelf way to do it, and looks good too.

Re: Chainplates

Posted: Thu Apr 08, 2010 12:31 pm
by falcon
Thanks for providing the details which I plan to emulate with my chainplates.
Pete