Projects run amok

Anything goes, as long as it falls under the general forum protocol and rules.
Post Reply
Figment
Damned Because It's All Connected
Posts: 2847
Joined: Tue Apr 08, 2003 9:32 am
Boat Name: Triton
Boat Type: Grand Banks 42
Location: L.I. Sound

Projects run amok

Post by Figment »

We've all had projects that have just snowballed and run amok, right?

My current mire is the roof rack for my wife's beetle. What began as a quick shot of rustoleum on the mounting brackets has grown to a full strip and repaint, complete with varnishing the wooden bits and replacing all fasteners. Fifteen minutes stretched to a dozen hours spread over two weeks..... Three dollars stretched to something like $60 or so.

I imagine that this is what happened to the guy who turned his Fatty Knees dinghy into one severely-overpacked-pony of a "lifeboat" (see the November/December issue of Good Old Boat). I mean, COME ON NOW! That must've been one really long winter.

Fess up, everyone. What have you gotten yourselves into lately?
dasein668
Boateg
Posts: 1637
Joined: Thu Apr 03, 2003 9:09 am
Boat Name: Dasein
Boat Type: Pearson Triton 668
Location: Portland, Maine
Contact:

Post by dasein668 »

Hmm. Lessee... I have no cabinetry installed on the port side of the saloon.... no engine in the boat... no hardware or wood remaining on deck...
Curmudgeon
Deck Grunge Scrubber
Posts: 48
Joined: Fri Apr 11, 2003 1:22 pm
Location: Land-locked Calgary, Alberta, Canada

Post by Curmudgeon »

The 'quick, dirty, and cheap' framework that was to hold the tarp over the boat has blossomed into lightweight, engineered plywood I-beams and three weeks of mind-numbingly repetative construction. While it will be wonderful to not have a boatload of snow to clear after every storm, I rue all that time spent on the frame. Note to self: K-I-S-S!
User avatar
Tim
Shipwright Extraordinaire
Posts: 5708
Joined: Tue Apr 01, 2003 6:39 pm
Boat Name: Glissando
Boat Type: Pearson Triton
Location: Whitefield, ME
Contact:

Post by Tim »

I once managed to turn a well-intentioned, but ultimately naive, notion to restore a small sailboat for $10,000 into a "might as well" bonanza of all-new systems and equipment costing significantly more. Very much like Figment's ski rack, but on a larger scale. (Of course, I'm thrilled with the results...)

Not only that, but that little innocent project led to the procurement of additional project boats--first another derelict sailboat for which I envisioned a drastic reconfiguration...then an antique wooden powerboat, which required a complete renovation...and then, helpless knave I be, I couldn't pass up a barbequed beauty. Just what I needed, of course.

Of course all this necessitated the construction of a large building in which to rebuild those projects. And now even that building is growing too small, so ultimately I'm sure there's something larger in my future...

And so goes the obsession. The thing of it is, I've never had so much fun in my life!
---------------------------------------------------
Forum Founder--No Longer Participating
Figment
Damned Because It's All Connected
Posts: 2847
Joined: Tue Apr 08, 2003 9:32 am
Boat Name: Triton
Boat Type: Grand Banks 42
Location: L.I. Sound

Post by Figment »

Sounds like a great story. If only there were a website to tell the whole tale.....
User avatar
Tim
Shipwright Extraordinaire
Posts: 5708
Joined: Tue Apr 01, 2003 6:39 pm
Boat Name: Glissando
Boat Type: Pearson Triton
Location: Whitefield, ME
Contact:

Post by Tim »

Figment wrote:Sounds like a great story. If only there were a website to tell the whole tale.....
I wish I'd thought of that. Rats. I should have documented more, too.
---------------------------------------------------
Forum Founder--No Longer Participating
Tony
Skilled Systems Installer
Posts: 223
Joined: Wed Apr 09, 2003 8:14 pm
Boat Name: S/V Bonnie Blue
Boat Type: Catalina 22
Location: Portland, Oregon
Contact:

Post by Tony »

Well, I bought an older 32' ketch with a lot of little problems and 2 or 3 bulkheads that needed to be replaced or repaired due to rot, and expected that to be the end of it...3-5K and I'm done. I'm now trying to remember if I recharged the 18V batteries of my sawzall in preparation for totally ripping out the interior of the salon down to the hull and starting over...I wasn't looking for a project on quite the scale of Glissando, nor do I really have that much cash at the moment, but, since I own it now...

Geez, the things we get ourselves into. Oh, and the rebuild should be interesting, since I really have to shop available...if it can't be done on the boat, it takes a WHOLE lot of creativity.
Tony
lindenberg

slowly I turn...

Post by lindenberg »

oh at first it was Ill just touch up the varnish inside and sail it...now I'm getting ready to sand the bejesus out of it inside and out build a new tiller and haul it out somewhere so I can redo the hull and get a new rudder. Already I've shamelessy leered at those sexy chrome lewmar winches with the self tailing option. For God sake man I have Paint chip samples snuck into the garage and a water proof tool box for paint strainers. The madness ...the madness...
User avatar
Tim
Shipwright Extraordinaire
Posts: 5708
Joined: Tue Apr 01, 2003 6:39 pm
Boat Name: Glissando
Boat Type: Pearson Triton
Location: Whitefield, ME
Contact:

Post by Tim »

Too bad no one here on the forum thinks like you do.... ;<)
---------------------------------------------------
Forum Founder--No Longer Participating
Post Reply